Building

Range of tools for carpentry-joinery is very large. We present the most necessary.

In addition to the instrument shown to have everything you need for sharpening and straightening carpentry-hundred-molecular tools: files, is the touchstone, hammers,

Pliers, and more, it depends on the host. The Germans – people neat and exacting for the procedure and work, they say that “the number of tool

Devices for the case will not hurt. ”

Point correction and adjustment tools

All tools must be roadworthy and properly sharpened. Sharpening axes, saws should be done regularly. We have shown in sharpening saws

Grip on the carborundum disk and is the touchstone, the following are the basic ways of sharpening with a file, editing and distributing the teeth with hammer a nail,

Show how to keep stringing Lutchkoff saw at the saw blade as a knife fastened to the planes, just attach it to any other boats (zenzubele, jointer

And others).

The ax blade at a point is pressed against the bars or the winepress. At the point ax drive up and down the abrasives, sharpened one side, proceed to the next. Sharpen up

Since then, until they get acute. The ax blade should cut a sheet of paper quickly. After the point of the blade to the right of final touchstone, one or two

The descent. The first descent is sharpened (down) at 38 mm from the blade, the second – on 18 mm.

To the point of use drinking nail files with a small triangular notch. It is more convenient to sharpen the saw in a vise or blocks. Pre-breeding teeth, ie, turn down

Alternately in one direction and then in another direction, one after the other by an amount less than the thickness of the saw blade and one half. There are special wiring or

Screwdriver set and steered between the teeth. The teeth slant on the same distance, this trim them. Changes to this tooth

Saw, hammer two nails in the timber at the right distance from each other and through them to smuggle in the teeth of the saw blade across. Teeth cross saws

Sharpened through one tooth at an angle of 45 degrees to the side of the saw blade. First, sharpen the teeth of the saw with one hand, and then the other.

When commissioning the boats, that is, planer, jointer, etc. Bailer should be inserted in the block (the body) so that she could shoot with shavings of wood details on the required

The thickness. The blade of the foot of the body should act by the same amount, without bias. Setting sharpened spoon, her wedge with

Use a hammer.

To establish Lutchkoff saw, pull saw blade so that it is straight, no wobble and did not make the curve cuts. With very strong

Pulling the fabric can break, it happens often and wobble saw.